regulate the safe operation of forklifts

Second, the scope of application: forklift driver;

Third, the forklift safety driving code:

1. You must pass the examination of the relevant department and obtain the special operation certificate issued by the government agency before driving the forklift and strictly observe the following safety procedures.

2. Care must be taken to carefully follow the operating procedures and be familiar with the vehicle's performance and road conditions in the operating area. Master the basic knowledge and skills of maintenance of forklifts, and carefully carry out maintenance and repair work for vehicles.

3. It is strictly forbidden to drive people, it is strictly forbidden to drive after drinking; no diet or chat is allowed during driving; mobile phone calls are not allowed on the way.

4. Before using the vehicle, it should be strictly checked. It is strictly forbidden to take the vehicle with a fault. It is not allowed to pass dangerous or potentially dangerous sections.

Fourth, forklift safety operation manual:

The operation of the electric forklift driver must comply with the requirements of the safety regulations

1. Check the effectiveness of the brake system and the battery power before running. If the defect is found, it will be processed before operation.

2. It is not allowed to use a single fork to run the cargo when carrying the cargo, nor to use the tip of the fork to pick up the cargo. It must be that the fork is completely inserted under the cargo and the cargo is evenly placed on the fork.

3, start smoothly, must first slow down before turning, normal driving speed should not be too fast, smooth brake parking

4, is not allowed to stand on the fork, the forklift is not allowed to run

5. Carefully carry large-sized goods, do not carry unfixed or loose goods.

6, check the electrolyte regularly, prohibit the use of open flame lighting to check the battery electrolyte

7. Before parking, do not lower the fork and place the forklift neatly, stop and disconnect the vehicle.

8. When the power supply is insufficient, the power protection device of the forklift will automatically open, the forklift fork will refuse to rise, and it is forbidden to continue to use the cargo. At this time, the truck should be driven to the position of the charger to charge the forklift.

9. When charging, first disconnect the working system of the forklift and the battery, then connect the battery to the charger, then connect the charger to the power socket and turn on the charger.

10. Under normal circumstances, the intelligent charger does not need manual intervention. The non-intelligent charger can manually intervene the output voltage and current value of the charger. Usually, the voltage output value is 10% higher than the nominal voltage of the battery. The output current should be Set to about 1/10 of the rated capacity of the battery. (For example, DC24V/210AH battery, charger output voltage and current can be set to 26V, 21A)